Before you start with the configuration below, please ensure that TSP-143LAN printer is connected to the router and your iPad is also connected to the same router. Please ensure that the thermal paper is loaded into the printer.
1. Identify the printer
Star Micronics TSP-143LAN belongs to TSP-100 Family series. You can identify the printer by looking at the bottom of the printer where the manufacturer sticker indicate the model.
2. Retrieve the printer setting
To check the printer setting, power off the printer, and execute below steps,
3. Configure Static IP for your printer
By default, TSP-143LAN will always shipped in Dynamic IP mode. With Dynamic IP setting, the printer is capable to self configure to connect to any network and this is very easy to setup and get your POS system up and running. But the Dynamic IP (DHCP) mode also means that the IP address will change, which cause some problem for Vend POS as Vend POS only recognize Static (Fixed) IP.
Following steps describe how to configure the printer to Static mode. If the attempt was not successful, your printer will still remains on DHCP mode. If you have mis-configure the setting and needed to reset the printer, please refer to the Reset Printer Settings below on hard reset the printer.
Please ensure that you have install Meraki MDM on your iPad, if not, please refer to Meraki MDM installation guide. Follow the steps below,
Open the Telnet Lite App
i. Configure Telnet Lite App
ii. Configure Static IP address in Telnet Lite
iii. Video Guide